Power Monitor

Edward Updated by Edward

The power meters provide an approximation of the power usage by your lighting rig. Using the power values in the patch detail for each fixture, the software can calculate the actual load on each of the power phases.

To use the power meters, you must supply the maximum power load in the “Power” column of the patch detail and the phase (1, 2 or 3) in the “Dimmer Phase” column. If the phase is left blank, then the channel will not contribute to the values displayed in the meters.

Voltage – Set the average voltage used by the power system in your building. For North America this is normally 120V. For most other countries this should be set to 220V.

 

Limit (Amp) – An upper limit on the power available per phase can be set using the “Limit” field. This setting is the limit per phase (not the total limit of all phases). When this is set (above 0) then the software will automatically adjust the grand master to keep the system within this limit.

How did we do?

Timecode Monitor

Virtual Console

Contact